Search Results for

    Show / Hide Table of Contents

    Common Task Settings

    The following settings are common across all tasks in Zynk.

    Settings

    Break on Failure

    Required
    If set to True the workflow will stop running if the task does not end successfully, otherwise the workflow will continue.

    Can Resume From Failure

    Required
    When a task fails and this setting is enabled, the status of the task will be set to 'Resume' rather than 'Fail'. This indicates that the workflow should start from this task the next time it runs. This means that the workflow will pick up from where it left off in the event of this task failing. This setting defaults to True.

    The Workflows setting in the workflow properties must also be True for this to work.

    If set to false, the workflow will start from the beginning even if this task fails.

    Enabled

    Required
    Set to True to run this task when the workflow is executed, otherwise it will be skipped. If a container task is not enabled none of the child tasks will be ran.

    Last Ran

    Optional
    The date the task was last ran.

    Last Result

    Required
    The end result of when the task was last ran.

    Log Debug Message

    Optional Set to true to log detailed information for debugging purposes.

    On Failure Task

    Optional
    An optional task to run if the task is unable to complete successfully.

    Task Name

    Required
    The name of the task within the workflow, it can be helpful if you have more than one of the same task.

    Task Type

    Read Only
    The type code of the task, this cannot be modified.

    Unique ID

    Read Only
    The unique identifier of the task, this cannot be modified.

    In This Article
    Zynk Documentation © 2020, Zynk Software Limited. Zynk is a registered trademark of Zynk Software Limited